Clip Up System® laying is simple and fast: in addition to clips and boards, just a hammer and a hacksaw are needed.
The subfloor must be flat, not elastic, smooth and suitable for laying wooden floor. Clip Up System® can be laid on screed, on existing floor, on cork mat or on the mat created by the Garbelotto Research & Development department, which works as an acoustic and vapor barrier.
It is carried out by means placed on the subfloor and with a little pressure hook them to the boards. With the same ease the boards can be removed, allowing the reuse of both planks and clips.
With Clip Up System®, you can quickly and easily replace a single board and it’s needed only a sucker to raise the damaged table and replace it. For brushed or hand planed parquet, you just need a small screw to raise the first board, the following ones can be removed without the need of holes.
Clip Up System® can also be used for laying the tiles of the Creator® Line, also making this type of wooden floor inspectable. For installation, 3 clips per square meter are required.
Clip Up System® is also available for the Hungarian herringbone installation, the Noblesse® line, both in thicknesses of 3 mm and 16 mm, with boards up to 170 mm wide.